AF泡沫泵凝結水泵 

凝結水泵如圖5-48所示。其可用于火(核)電機組的凝汽器中輸送凝結水及給排水工程。正常情況下，泵筒體內處于負壓狀態，故要求泵汽蝕性能好。為了滿足這一要求，泵首級可做成雙吸或首級葉輪前加誘導輪或泵機組加長，增加倒灌高度。吸入和吐出口可以分別位于圓簡體或吐出座上。兩者可以做成180°、90°等任意角度位置來滿足要求。
凝結水系的特點:噪聲低，振動小，運行平穩可靠，效率高，壽命長，安裝維護方便等。
泵中間設有多處導軸承，用以支撐泵轉子徑向力及其模動。泵轉子的軸向力和其質量教由電動機上推力軸承來承受，也可以設計成雜上加推力軸承結構。泵轉 子內部軸間用卡套式(見圖565)聯軸器連接，小型泵用螺紋筒形聯軸器連接。當泵的軸向力及其質量由電動機承受時，  泵轉子的軸與電動機軸用剛性聯軸器連接，如圖5-53所示。

AF foam pump condensate pump

The condensate pump is shown in Fig. 5-48. It can be used for condensate transmission and water supply and drainage works in the condenser of thermal (nuclear) power unit. Under normal conditions, the pump barrel is under negative pressure, so it is required to have good cavitation performance. In order to meet this requirement, the first stage of the pump can be made into double suction or the inducer or the pump unit can be lengthened in front of the first stage impeller to increase the pouring height. The suction and discharge ports may be respectively located on the cylindrical body or the discharge seat. The two can be made into any angle position such as 180 ° and 90 ° to meet the requirements.

Characteristics of condensed water system: low noise, small vibration, stable and reliable operation, high efficiency, long service life, convenient installation and maintenance, etc.

A plurality of guide bearings are arranged in the middle of the pump to support the radial force of the pump rotor and its mold movement. The axial force of the pump rotor and its quality can be borne by the thrust bearing on the motor, or it can be designed as a hybrid thrust bearing structure. The internal shafts of the pump rotor are connected with ferrule type (see Fig. 565) couplings, and small pumps are connected with threaded cylindrical couplings. When the axial force and mass of the pump are borne by the motor, the shaft of the pump rotor and the motor shaft are connected by rigid couplings, as shown in Fig. 5-53.